Overview
The goal of this page update is to provide guidance for editors relevant to lessons learned in handling real-time closures (RTC) and cross-traffic at junctions.
| This information is a draft under development. It should not be considered official guidance. |
Content
Junctions and cross traffic
When adding a Real-Time Closure consider whether any cross traffic will be blocked as well.
Often in work zones and for special events (parades, 5K and 10K road races, marathons, half-marathons, festivals) cross traffic is not allowed at one or more junctions.
It has been observed that Waze will not route across a closed segment; however, it will route on to or off of a close segment to reach a destination on that segment. If traffic going across your Real-Time Closure must be blocked at a junction, you will need to close at least one of the cross street segments as well.
- One-way cross street
- Close the cross street s-in segment.
- This prevents traffic from routing through the junction and onto closed segments to reach a destination.
- Two-way cross street
- Close both cross street s-in segments in both directions.
- Closing a single segment will allow routing across the juction to destinations on that segment.
- T-intersections
- Close the cross street s-in segment in the direction approaching the junction.
- This is necessary only to stop routing to destinations on s-out segments of the main closure.
[NOTE: Images need to be updated]
1.
2. 
3. 
Discussion
This proposal is still being drafted prior to open discussion.