Changes

From Wazeopedia

Places/Parking lot

144 bytes added, 2 years ago
clarify lots above streets can be drawn overlapping the street.
For planned parking features to be announced later, it's important that the shape of the polygon be drawn as close as possible to the actual shape of the parking lot, including the entry/exit location. Keeping in mind that for multi-level garages, only the footprint of the structure should be outlined.
If a lot spans both sides of a street (not counting PLRs obviously), it must be mapped so '''the polygon does not overlap the street'''. This may require drawing the lot as separate places.<br />''If the lot is elevated above the street however, and the lot actually covers the street, then the PLA may overlap the street as well.''
For underground garages it is not important to draw the polygon to match the internal perimeter since there is no GPS signal underground. It is important that the polygon includes any above ground areas, and the underground areas near any entrances or exits in a single polygon. If a lot has more than one entrance/exit the polygon must be made to connect all the entrances and exits. You may use a PLR to show multiple entrances as well, allowing the routing to choose the best route to access the lot, just as an above ground lot is drawn. It is not important however to draw the polygon to the entire footprint of the garage. The accuracy of the entry point ('''[[Places#Setting the stop point for a Place|Setting the stop point]]''') is very important. {{Clear}}