(Added OSX multi-select key) |
(Obsoleted - these instructions are no more applicable on WME.) |
||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
{{Obsoleted}} | |||
* Select a road segment | * Select a road segment | ||
* Hold down the Control key (Windows) or Command key (Macintosh) and select a junction | * Hold down the Control key (Windows) or Command key (Macintosh) and select a junction | ||
| Line 4: | Line 6: | ||
* From the Edit Panel, click on "Switch road between nodes" | * From the Edit Panel, click on "Switch road between nodes" | ||
Notes: | Notes: It seems you must have driven near these junctions for this command to work, even if you are an Area Manager. The order of picking junctions does not seem to matter. | ||
Latest revision as of 17:21, 17 February 2015
 |
This information is obsolete and the active links to this page have been reviewed for disconnection or replacement. More current alternate information is likely available and should be followed rather than this information. |
- Select a road segment
- Hold down the Control key (Windows) or Command key (Macintosh) and select a junction
- Continue holding the Control or Command key down and then select a second junction
- From the Edit Panel, click on "Switch road between nodes"
Notes: It seems you must have driven near these junctions for this command to work, even if you are an Area Manager. The order of picking junctions does not seem to matter.