USA/Southeast/City Field: Difference between revisions Discussion View history

< USA‎ | Southeast
Line 20: Line 20:
Check if your segment / place falls within the city limits by using the appropriate state's mapping resources ([[Alabama/Mapping_Resources| Alabama]], [[USA/Southeast/Florida/Mapping resources|Florida]], [[Georgia/Mapping_Resources| Georgia]]).
Check if your segment / place falls within the city limits by using the appropriate state's mapping resources ([[Alabama/Mapping_Resources| Alabama]], [[USA/Southeast/Florida/Mapping resources|Florida]], [[Georgia/Mapping_Resources| Georgia]]).


Within City Limits?
Is the segment Within the City Limits?


[[#Incorporated City Name|Yes - Incorporated City Limits]]
[[#Incorporated City Name|Yes - Incorporated City Limits]]

Revision as of 00:15, 6 December 2015

Use the following checklist step-by-step to determine whether the "City" field for a segment or place should contain a name or be marked as "None":


Mailing Address for City field in Waze

NOTE: Mailing addresses alone are not a determining factor for filling in the City field; city limits are. For example, everyone who lives in Leon County has a "Tallahassee, FL" mailing address, but not everyone in Leon County lives within the incorporated city limits of Tallahassee. Most unincorporated county areas should have the City field checked as "None", unless they meet one of the following exceptions.

Start

Step 1 : Incorporated Municipality

Is the segment within a city on the list of legally incorporated municipalities for Alabama, Florida, or Georgia?

YES? Verify City Limits

NO? proceed to STEP 2

Step 1a - Verify City Limits

Check if your segment / place falls within the city limits by using the appropriate state's mapping resources ( Alabama, Florida, Georgia).

Is the segment Within the City Limits?

Yes - Incorporated City Limits No - Step 2 CDP

Step 2 - Census Designated Place (CDP)

Is it on the list of census designated places at the bottom of the page below the state map ( Alabama, Georgia,Florida)?

No? Step 3

Yes

Step 2a

The geographic boundaries of CDP's can be viewed at the links above by clicking on the correct county, or they can be overlaid on WME by following the presentation Overlay CDP's on WME by t0cableguy

STEP 3 - County Property Appraiser

If you look up a parcel on the roadway in question using a PA's website from your state's mapping resources page ( Alabama, Florida, Georgia), does it list your target name as a valid address? If NO, proceed to Step 4. If YES, try to determine the boundaries for use of that City name by checking subsequent parcels in the area or checking county GIS sites for your state ( Alabama, Florida, Georgia).

STEP 4 - Indian Reservations / Government Installations

Is the segment / place located on an Indian Reservation or Government Installation? If NO, proceed to Step 5. If YES, listing the name of the reservation or installation in the City field may be appropriate. If you think YES, consult a State Manager or Regional Coordinator for more guidance.

STEP 5 - Other Place of Significance.

There are many other Census Designated Places and points of interest throughout Florida, but many are small. Does your target location have a major cultural significance (e.g. tourist attraction, county seat, travel milestone (e.g. Yeehaw Junction))? If you think YES, consult a State Manager or Regional Coordinator for more guidance. If NO, then mark the City field as "None". Stop here, you're done. There are no more options.

Options for City Name Field

Incorporated City Name

Segment is within an Incorporated City's Limits. Please use the city name in the city field.

Census Designated Place(CDP)

Segment is within a Census Designated Place's(CDP) boundary. Please Use this CDP in the city field.

No City

Segment is not within any of the possible city name options. Please check None for the city field.





Flowchart

The following flow-chart outlines the discussion from above: