Vyhľadávanie nenašlo žiadne výsledky.
- When creating a segment, it is important to ensure that any individual segment is at least REDIRECT USA:Segment length/Minimum. It is less important toWhen a segment is less than REDIRECT USA:Segment length/Minimum it becomes difficult for the navigation engine to determine traffic speed through thatsmall segments to be created between the two junctions along that main road. If the segment is shorter than REDIRECT USA:Segment length/Minimum, it mayIn the above cases, the segment is necessary so it cannot be deleted, but it can be made the minimum length and still meet the needs of the original purposeCut ~ To separate a single segment into two smaller segments, by adding a junction node along the segment. See the Cut a segment Wiki Page Related entries:
- ==Usage== Place <code>{{:Segment length/Minimum}}</code> on any page where you want to display <code>{{:Segment length/Minimum}}</code>. <includeonly> <change the individual pages. Place {{:Segment length/Minimum}} on any page where you want to display Segment length/Minimum.is for routing-guidance stubs whose lengths are very short — subject to the Segment length/Minimum minimum-length requirement — so that their names willstandard road segment (not a parking lot road or private road). You should use a short "stub" length no less than Segment length/Minimum of a standarddeviate from these precise configurations. Each "stub" segment should be Segment length/Minimum long. This is long enough so it will not cause routing==Usage== Place <code>{{:Segment length/Minimum}}</code> on any page where you want to display <code>{{:Segment length/Minimum}}</code>. <includeonly> <change the individual pages. Place {{:Segment length/Minimum}} on any page where you want to display Segment length/Minimum.is for routing-guidance stubs whose lengths are very short — subject to the Segment length/Minimum minimum-length requirement — so that their names willstandard road segment (not a parking lot road or private road). You should use a short "stub" length no less than Segment length/Minimum of a standarddeviate from these precise configurations. Each "stub" segment should be Segment length/Minimum long. This is long enough so it will not cause routing