# Routing penalties/Controlling U-turn penalties

## Contents

### Median U-turn penalty

For the latest discussion on this section please visit the wiki forum thread. |

It is possible for this method to fail to prevent a U-turn when it is the first segment of a route or reroute. If you observe this method to fail when it is implemented properly, please report it in this forum thread |

The Waze routing algorithm assesses a penalty for a double-left or -right turn, which can be used to prevent U-turns at box- (#) and H-style intersections on divided highways and parallel roads.

#### Preventing median U-turns

A large U-turn penalty is applied for a double left/right turn when * all three* of the conditions below are met:

- The U-turn is composed of an incoming segment, a single median segment, and an outgoing segment
- The length of the median segment is shorter than 15 m (49.21 feet)
- The incoming and outgoing segments are within ±5° of parallel to each other

#### Allowing median U-turns

To allow a U-turn through a median, ensure that any one of the above criteria are broken:

- To allow the median U-turn in both directions, it is simplest to make the median segment longer than 15 meters.
*(Breaking condition #2)* - To allow the U-turn in only one direction, it is simplest to adjust the turn angles in only for the segments of the allowed U-turn so they are wider than the ±5° allowance of exactly parallel. This is easily achieved without affecting the overall look of the map using a Micro-dogleg.

#### Checking for parallel segments

A convenient way to check if the two side segments are parallel is to use another segment as a reference tool. If the median segment has no geometry nodes, it can be the reference segment. Otherwise you can draw a new segment as a reference tool with no geometry which connects the A and B nodes of the median segment. *The reference segment can be deleted after the check is complete, if appropriate.*

Check two angles:

- X — the angle between the incoming one-way segment and the reference segment
- Y — the angle between the outgoing one-way segment and the reference segment.

If the sum of these two angles is within 5° of 180° (between 175-185°), then the roads are considered parallel.

In the example below, angle X is 102°, and angle Y is 75°. The sum is 177°, which is within 3° of 180°. Therefore these roads are considered parallel.